Firmware Image Generation

TODO.

Configuration Generating Modules

TODO.

Build Channel

TODO.

Build Version

TODO.

Platforms

TODO.

Device Descriptors

Nodewatcher device descriptors are defined in nodewatcher/modules/devices and are normal Python modules. The best way to define a new descriptor is to extend an already existing one. This can be done if a similar device is already supported (has a descriptor) and you just need to modify some minor things. In this case your new descriptor may simply extend an existing one using Python class inheritance and omit some of the attributes. In any case identifier and name must be defined (and be unique).

The following things need to be determined for a device descriptor:

  • identifier is an all-lowercase unique device identifier, which should consist of a manufacturer prefix, a model identifier and a version.
  • name is a human-readable device name consisting of a model identifier and a version. It should not contain a manufacturer name.
  • manufacturer is a human-readable manufacturer name.
  • url is an URL containing more information about the device.
  • architecture identifies the OpenWrt architecture that the device needs (eg. ar71xx).
  • antennas is a list of antenna descriptors, which describe physical antennas attached to the device by default.
  • radios is a list of radio descriptors, which describe radios present on the device. Each radio specifies the protocols that it supports, antennas that it has attached and features that it supports. Each radio is identified by its logical identifier, which is platform-independent (eg. wifi0).
  • switches contains a list of switch descriptors, which describe ethernet switches present on the device. Each switch is identified by its logical identifier, which is platform-independent (eg. switch0). Each switch can also define multiple VLAN presets that can be used when configuring the switch. If the switch supports custom configuration, it should have the configurable attribute set to True.
  • ports contains a list of ethernet ports, which describe physical ethernet ports. Each port is identified by its logical identifier, which is platform-independent (eg. wan0, lan0, etc.).
  • port_map contains the mapping of logical port names to platform-specific identifiers (one mapping per platform, eg. OpenWrt). It maps all platform-independent identifiers (eg. wifi0, switch0, wan0, lan0) to identifiers used on a specific platform (eg. radio0, switch0, eth1, eth0). For switch configurations a special SwitchPortMap instance may be used to define VLAN interface naming.
  • drivers defines the drivers used by the radios on each platform. For example, on OpenWrt this may be mac80211.
  • profiles define the platform-specific device profiles that should be used when building an image and paths to the resulting firmware files. Note that a single profile may be used for multiple devices. For example, on OpenWrt a profile TLWR741 generates a firmware file openwrt-ar71xx-generic-tl-wr741nd-v1-squashfs-factory.bin for the TP-Link WR741NDv1 device and this must be configured here. The firmware filenames can also contain filename patterns containing ? and * to match different filenames at once.

The best way to determine the values for radios, switches, ports, port_map and drivers is to boot a stock version of OpenWrt on the device and check the default configuration inside /etc/config/network and /etc/config/wireless.

OpenWrt profiles may be listed by running make info on the generated image builder.